 |
|||||||||
|
|||||||||
info@gentrymfg.com
Phone (631) 580-1515 • FAX (631) 580-7250 • Toll Free (800) 231-4830
| Repair Your... | |||||||||
UPPER KNIFE HOLDER |
|||||||||
| At a FRACTION of the Full Replacement Cost | |||||||||
| For the following Cheshire / Videojet Labeling Heads: | |||||||||
| 100280-01 | Upper Knife Holder 14" (713,721,722 Head) | ||||||||
| 100104-00 | Upper Knife Holder 15" (537,538 Head) | ||||||||
| 100104-01 | Upper Knife Holder 18" (539,540,R9000 Head) | ||||||||
| ** IF YOUR UPPER GUILLOTINE KNIFE IS NOT CUTTING | |||||||||
| PROPERLY, IT IS MOST LIKELY CAUSED BY AN IMPROPER | |||||||||
| FIT BETWEEN THE CASTING AND GIBS ON EACH SIDE. | |||||||||
| (THE CASTING WEARS AWAY WITH AGE AND ALLOWS THE | |||||||||
| GIBS TO FLOAT.) | |||||||||
| Solution: | Gentry can machine the upper knife holder on each side to accept a hardened steel housing which replaces the worn gib end. | ||||||||
| Result: | You now have an Upper Knife Holder | ||||||||
| that operates like new. | |||||||||
| Cost: | Machine both gib ends to accept housing | $215.66 |
|||||||
| Install (2) Housing Gib @ $86.76 each | $173.52 |
||||||||
| Oil Cup (If required, each) | $11.75 |
||||||||
| Heli Coil (If required, each) | $24.30 |
||||||||
| New Gibs (If desired, GM-1300, each) | $61.72 |
||||||||
| NORMAL TURN-AROUND TIME = 2 to 3 Days | |||||||||
| *Expedited 1-Day Service available in emergencies | |||||||||
| (with prior notification) at an additional cost of $75.00. | |||||||||
| Home | About | Contact | Tour | Parts | Email |
©2008 Gentry Manufacturing All
Rights Reserved